L'Antre du Tryphon

This is a single case for the MKS PI and the TS-35 display running Klipper from MakerBase. This case combines the MKS PI board and the display into a single

This is a parametric round stand to display circular objects vertically. An example is given below that has a 67 mm diameter. Support material is not required. An infill of

This is a set of separators for the Dewalt shallow organizer buckets. This design is inspired from the design of ChristosMeletis on Thingiverse: https://www.thingiverse.com/thing:3075465. It solves the issue that the

This is a set of separators for the Dewalt deep organizer buckets. This design is inspired from the design of ChristosMeletis on Thingiverse: https://www.thingiverse.com/thing:3075465. It solves the issue that the

This is a variation of my pen holders that was published a while ago. This version has a drawer. The top part of it can hold index cards 5″ x

This is a storage box for the commonly available power meter on AliExpress. Support material is not required. An infill of 20% is recommended. This object was designed using openScad.

This is a TronXY X5SA bed spring tensioner and guide. This object was designed to increase the tension on the bed strings. It maximizes the space between the bed and

This is a case for an Orange PI 3 LTS Case. It provides the required space of the heat sinks and a 30 mm fan. It also has an antenna

This is a case for the White Noise Generator kit https://www.aliexpress.com/item/32842450015.html?spm=a2g0o.order_list.0.0.79b518023Tw819 . Support material is not required. An infill of 20% is recommended. This object was designed using Solid Edge

This is a storage box for a single Revo Nozzle. Support material is not required. An infill of 15% is recommended. This object was designed using Solid Edge Community Edition.

These openSCAD parametric object generates bits and blades holders for the DeWalt Tough Cases. It can generate horizontal hexagonal bit holders, arbitrary angled hexagonal bit holders along with T-blade Jigsaw

This is the version 2 of a simple guide that strengthen the PTFE tube at the extruder output of a TronXY X5SA printer. You will need a M4 x 12

This is a parametric tray generator for Wera micro screwdrivers. The trays are optionally stackable. The STL are given as a basic set of trays. You may generate trays for

figure class=”wp-block-table”> This is a parametric small parts tray. The handle showed on the picture can be easily removed by setting a variable if not needed. Documentation is provided in

This script creates a square drilling template. It was mainly designed to generate drilling templates for power bars since they are often install in awkward places and marking the drilling

This is a simple case for an Altec Lansing Baby Boom XL Case bluetooth speaker. Support material is not required. An infill of 15% is recommended. This object was designed

This is a simple emergency switch holder for a 3018 CNC. The diameter of the hole for the switch is 13 mm. The normally open switch can be connected on

This is a 100 mm high cotton pad container. The cotton pad container has a diameter of a bit less than 60 mm. Support material is not required. An infill

This is a 100 mm Zip Tie Container. It can contain more than 500 zip ties. It is divided in 10 compartments. Support material is not required. An infill of

This is a small flashlight holder that can be screwed on a wall and so on. It is specifically design for a Police Security 3 cubs flashlight. Support material is