This is a cable holder for the Ikea Vattenkar organizer. A M3 x 6 mm nut and bolt or equivalent are required for assembly.

This is a bottle stabilizer parametric model. For now, it contains the configuration for Robert Oster and Noodle's ink bottles.

These are two add-ons for the Desiccant Spool Tumbler designed by chuyskywalker (https://www.printables.com/model/436044-desiccant-spool-tumbler). I like the design. I'm constantly using them. A funnel is provided to fill them out with desiccant. The cover is a bit difficult to open or close, which is great, preventing the desiccant from escaping. A handle is also provided to help close and open the tumbler.

This is a parametric funnel with optional hanging loop and angled stem.

This is a device that holds cards that identify the filament loaded in the Bambu Lab AMS unit. The size of the cards are 42.3 mm x 76 mm which corresponds to a 1/3 of a 5 x 3 inches index card. The numbers are highlighted using a Sharpie. A template that let you print 3 cards per index card is also include.

These are din rail mounts for an Arduino Uno and Mega 2560 or any board that has these form factors. The din rail clip can be attached temporarily to the Arduino base using a piece of 1.75 mm filament. The clip can be attached horizontally or vertically to the Arduino base. It can also be glued to the Arduino base for a permanent setup. The clip shall be printed on its side. The spacers shall be put between the base and the Arduino board, held by the screws. Four or six M2.5 x 8 mm screws are required, but may be substituted.

These are din rail breadboard mounts for 400 and 830 points breadboards. The din rail clips can be attached temporarily to the breadboard base using a piece of 1.75 mm filament. The clips can be attached horizontally or vertically to the breadboard base. They can also be glued to the breadboard base for a permanent setup. Clips shall be printed on their side. The 830 points Breadboard base needs two clips.

This is a small chromatography container. It can hold paper up to 5 cm in width, from 50 mm to 120 mm in length. The length given in the filename is the maximum length of the paper supported.

This is another Bambu Lab Magnetic Poop Container. It fits the P1P, P1S and the X1 series. Magnet up to 12 mm in diameter can be used. Their thickness can be 2 mm, 3 mm and/or 4 mm. Up to 4 magnets of each size can be used. Usually 2 of them is enough.

This openSCAD script create feet for projects. It was designed for aluminum extrusion, but can be used for other purposes. The thickness of the sides will have an impact on vibration dampening. TPU is recommended. The given example is for 20 x 20 mm extrusion using a M5 bolt.