Dust collector for drills
January 14, 2023
· admin
3D Printing
object
This is a simple dust collector used when you drill a hole on a wall. It replaces my cardboard version of it.
Makebase MKS PI and TS-35 Case
January 6, 2023
· admin
3D Printing
object
These are cases for the MKS PI and the TS-35 display running Klipper from MakerBase. These cases let you mount the MKS PI and the TS-35 separately on your 3D Printer.
Makebase MKS PI and TS-35 Case
December 30, 2022
· admin
3D Printing
object
This is a single case for the MKS PI and the TS-35 display running Klipper from MakerBase. This case combines the MKS PI board and the display into a single module.
Parametric Round Display Stand
December 24, 2022
· admin
3D Printing
object
This is a parametric round stand to display circular objects vertically. An example is given below that has a 67 mm diameter.
Dewalt Shallow Organizer Separators
December 17, 2022
· admin
3D Printing
object
This is a set of separators for the Dewalt shallow organizer buckets. This design is inspired from the design of ChristosMeletis on Thingiverse: https://www.thingiverse.com/thing:3075465. It solves the issue that the lid of the organizer wasn't closing properly.
Dewalt Deep Organizer Separators
December 9, 2022
· admin
3D Printing
object
This is a set of separators for the Dewalt deep organizer buckets. This design is inspired from the design of ChristosMeletis on Thingiverse: https://www.thingiverse.com/thing:3075465. It solves the issue that the lid of the organizer wasn't closing properly.
Pen Holder V03
December 3, 2022
· admin
3D Printing
object
This is a variation of my pen holders that was published a while ago. This version has a drawer. The top part of it can hold index cards 5" x 3".
Power meter storage box
November 26, 2022
· admin
3D Printing
object
This is a storage box for the commonly available power meter on AliExpress.
TronXY X5SA Bed Spring Tensioner
November 18, 2022
· admin
3D Printing
object
This is a TronXY X5SA bed spring tensioner and guide. This object was designed to increase the tension on the bed strings. It maximizes the space between the bed and the bed frame, so I could use the shown build plate clips. Without these, some of the bed level spring would have nearly no tension on it. It also keeps the spring strait. You'll have to print 6 of these.
Orange PI 3 LTS Case
November 12, 2022
· admin
3D Printing
object
This is a case for an Orange PI 3 LTS Case. It provides the required space of the heat sinks and a 30 mm fan. It also has an antenna holder. Four mounting holes are provided on the bottom of the case. I strongly suggest that if you use metal screws, put a piece of tape on them to protect your Orange PI.