Parametric Vesa Monitor Extension
June 28, 2025
· admin
3D Printing
object
This is a parametric Vesa Monitor extension. Be careful of the length of it since it's made of plastic. It may either break or you mounting device will break. Use it at your own risk. I'm using it for a 27-inch monitor, held by a vertical 1.25 inch tube. I've added a strain relief but be put at the bottom of the extension between the extension and the holding tube. You will need 8 M3 x 45 mm, 8 M4 x 20 mm hex cap screws, 4 M4 nuts along with 4 M4 washers.
Filament Bag Electric Air Pump Case
June 7, 2025
· admin
3D Printing
object
This is a case for a filament bag electric air pump widely available.
Utensil Dripper - Dryer
May 31, 2025
· admin
3D Printing
object
This is a utensil dripper/dryer, mainly used to air dry utensils. A riser is provided. It let any water that went underneath the dripper dry. A few drops of glue is required is the riser is installed.
Make nvim-tree width dynamic
May 26, 2025
· admin
Unix
Ubuntu
Ubuntu 20.04
NVIM
Create a file named ~/.config/nvim/lua/plugins/nvim-tree.lua and put the following content:
How to merge two git repositories
May 25, 2025
· admin
GIT
These steps will let you merge a source repository into a destination repository.
Ikea Ivar Pole Cylinders
May 24, 2025
· admin
3D Printing
object
These objects are a pair of slanted cylinders that are installed on a post of an Ikea Ivar shelving unit. They can be used to hold flashlights, cans, and so on. A small length of 1.75 mm filament is required to attach the cylinders to the post. Filament is used instead of screws.
Parametric Watering Can
May 18, 2025
· admin
3D Printing
object
Parametric Watering Can
--------------------------------------------------------------------------------
Parametric Wire Tube Holder and Wire Cap
May 10, 2025
· admin
3D Printing
object
These are a parametric wire tube holder along with a parametric wire cap for already installed wires. A single screw is needed to install one tube holder.
Case for a UT353 Sound Meter
May 3, 2025
· admin
3D Printing
object
This is a case for a Uni-T UT353 Sound Meter. It is designed that the foam doesn't touch any surface to prevent deformation. A drop of glue is required to glue the cover lock on the cover itself.