Electroluminescent Wire (Neon) Power Supply Holder
November 9, 2024
· admin
3D Printing
object
This is an electroluminescent wire (neon) power supply holder. Two screws are required to mount it.
Clips For Electroluminescent (Neon) Wires
November 2, 2024
· admin
3D Printing
object
These are clips For electroluminescent (neon) wires of 2.25 mm in diameter. Small nails or glue is required to install them. 16 of them are printed at the time. You'll need to cut them out.
Belt Tension Gauge Case
October 26, 2024
· admin
3D Printing
object
This is a box to store a Belt Tension Gauge that can be bought on various Chinese website.
TronXY X5SA Entruder and Filament Sensor Mount
October 19, 2024
· admin
3D Printing
object
This is a mount for the extruder and the filament sensor for the TronXY X5SA. It replaces the stock mounts. This mount was designed to move both the extruder and the filament sensor in the middle of the back side of the printer. You can then shorten the Bowden tube by about 20 cm (8 inches). You'll need a two 8 mm M5 screws with two T-nuts to mount it to the frame of the printer. You'll also need two M3 20mm screws with nuts to mount the filament sensor to the extruder mount.
Parametric Trays
October 12, 2024
· admin
3D Printing
object
These openSCAD scripts generate square, round, rounded corner square trays. Modify the file RoundTray.scad, SquareTray.scad or RoundedCornerSquareTray.scad to get the corresponding tray. ParametricTrays.scad should not be modified
Coffee Filter Dryer
October 5, 2024
· admin
3D Printing
object
This is a coffee filter dryer. It also has many other uses such as plant pot base.
MRB063A USB Cable Checker Case
September 28, 2024
· admin
3D Printing
object
This is a case for a USB Cable Checker model MRB063A available from many sources such as AliExpress. The top part shall be printed with is face on the bed. The 3mf file contains the top part with lettering to be printed with 2 colors. The USB B connector cap must be glued with a few dabs of superglue. 4 2.5 mm x 5 mm brass inserts along with 4 M2.5 x 8 mm screws are required. They can be replaced with other screws without brass inserts.
Craftsman Flex Claw Holder
September 21, 2024
· admin
3D Printing
object
This is a minimalist holder for the Craftsman Flex Claw Holder.
MySQL client does not use the port parameter
September 14, 2024
· admin
MySQL
Database
It will happen if you use localhost as the server address. The client will then use the Unix sockets. Use 127.0.0.1 instead. This issue is common when using SSL tunnels.
Box for a Plastic Welder
September 14, 2024
· admin
3D Printing
object
This is a box for the XCER-110 plastic welder. You will need a dab of glue to attach the lock pin to the cover. A bit of bubble wrap will prevent the welder from moving, but not required. The text in the pictures was added using the slicer.