Ikea Ivar Caliper and Folding Ruler holder
July 22, 2023
· admin
3D Printing
object
This is a holder for a Caliper and Folding Ruler for the Ikea Ivar. It is designed for the side units. The width of the folding ruler is 1.6 cm. The width of the caliper with its case is 2.8 cm.
Parametric Clickable Stamp Case
July 16, 2023
· admin
3D Printing
object
This is a parametric clickable stamps case. It fit out of the box the stamps distributed by Michaels'. The item numbers of these stamps are 10656553 and 10656558.
Triple 5mA battery trickle charger
July 8, 2023
· admin
3D Printing
object
Triple 5mA battery trickle charger
--------------------------------------------------------------------------------
Pen Holder V05
June 30, 2023
· admin
3D Printing
object
This is another variation of the pen holder published previously. This one is the largest. It can hold about 64 pens. The top part of it is modular. It can be redesigned and printing the whole pen holder is not required. The current version can hold sticky notes, rulers, etc. The U shape part is used to raise the second section of the top. It is not mandatory to use it.
Parametric Container with an overlapped lid
June 25, 2023
· admin
3D Printing
object
This is a parametric container with an overlapped lid.
8 ml Inkwell
June 10, 2023
· admin
3D Printing
object
This is a small 8 ml inkwell design to be used to refill a fountain pen. Test it with water before putting ink in it. Printing parameters may prevent it from being water tight.
Parametric Stamp Handle
April 29, 2023
· admin
3D Printing
object
This is a parametric stamp handle. It works pretty well with silicon stamps. I've used superglue to attach the stamp to the handle. A sample STL file is provided. Use OpenSCAD to create one that fits the dimensions you need.
Simple human interface for Home Assistant
April 22, 2023
· admin
Hardware
3D Printing
object
automation
ESP8266
NodeMCU
IoT
Internet of Things
Electronic Component
This is a simple human interface project for Home Assistant. It helps me remind doing 2 daily tasks. Using Home Assistant automation, it lit a LED at a given time and use the corresponding button to reset it when I'm done.
Manna Water Bottle Stand
April 15, 2023
· admin
3D Printing
object
This is a stand used to dry a Manna water bottle.
Foldable To-do List Manager
April 1, 2023
· admin
3D Printing
object
This is a stand for managing to-do lists based on 1/8 of a letter size sheet of paper or 3" x 5" index cards. Templates are included for you to draw your to-do lists. It can also be used as a separator. You will have to cut a letter size sheet of paper in eight pieces, or use out of the box 3" x 5" index cards. Each 1/8 of a letter size sheet piece will be 4" 1/4 by 2" 3/4 (10.8 x 7 cm). The to-do list manager may be folded to carry it.