Another Pen Holder
April 17, 2021
· admin
3D Printing
object
This is a pen holder of an unusual design. Three sizes are available. You can increase the capacity of them by gluing another one on its side.
How to move a directory from one git repository to another one preserving the history
April 11, 2021
· admin
GIT
These simple steps will let you move a directory contained within a git repository into another one while preserving the history.
Waveshare Pi Pico Dual Expander Base Plate
April 10, 2021
· admin
3D Printing
object
This is a baseplate for the Waveshare Pi Pico Dual Expander. You will need 4 tiny screws to mount it. An infill of 15% is recommended. Support is not needed.
1802 Membership Card Stand
February 26, 2021
· admin
3D Printing
object
This is a simple stand for the 1802 (COSMAC ELF) Membership Card. The 1802 is a vintage micro-processor. You can get this kit at http://www.sunrise-ev.com/1802.htm . I'm not affiliated with the seller in anyway. I bought the kit.
LG 27EA33 Storage Trays
February 21, 2021
· admin
3D Printing
object
This is a tray designed to be installed on the stand of an LG 27EA33 monitor. You need to print the STL file provided and the same file mirrored. You will then need to glue them together.
Panavise 303 replacement pads
January 25, 2021
· admin
3D Printing
object
These are replacement pads for the Panavise 303 vise. It has groves to hold tubular objects. I've printed it in semi-flexible filament, but works fine printed in PLA.
SBC Server Case
December 28, 2020
· admin
3D Printing
object
This is a modular SBC or Development Board enclosure. Its base design principle is you stack on top of each other plates that hold various devices such as Raspberry PI, Arduinos, ESP32, hard drives, etc. You can customize it the way you like. You may need some plates not provided yet. Feel free to contact me if some plates are needed.
3.5 inch Hard Drive Box
November 8, 2020
· admin
3D Printing
object
This is a box for a 3.5 inch hard drive and its cover. It was specifically designed to fit in a small safety box often rented by banks.
Electronic Bench Organizer
November 1, 2020
· admin
3D Printing
object
This is an organizer especially designed for an electronic bench to hold small parts, screws, etc.
Magazine File
October 25, 2020
· admin
3D Printing
object
This is a magazine file 60 mm wide. It is designed for letter size paper. It is by design a bit smaller than the document it holds. It has holes to mount it on the side of a desk.