Ikea Ivar Vesa 100mm Mount
February 29, 2020
· admin
3D Printing
object
This is a 100 mm VESA mount designed to be mounted on the Ikea Ivar side units. As shown on the picture, I have used it to mount a small monitor.
Ivar Side Unit Pin Hook
February 23, 2020
· admin
3D Printing
object
This is a small pin design to hang stuff on the vertical post of Ikea Ivar side units. The pin is 3mm in diameter, 10 mm long.
Zip Tie Sleeves for the Ivar System
February 17, 2020
· admin
3D Printing
object
This is a sleeve for Zip Ties. Its main utility is to protect the vertical supports of the Ikea Ivar system when using Zip Ties to attach stuff. They support zip ties up to 5 mm wide.
EN-EL10 Battery Tray
January 18, 2020
· admin
3D Printing
object
This is two battery tray design for the EN-EL10 batteries. They are used by Nikon for their point and shoot cameras. One of the design holds 6 batteries while the other one holds 4 batteries at an angle for a lower overall height.
IN-12B Nixie Tube Storage Tray
January 11, 2020
· admin
3D Printing
object
This is a storage tray designed to hold 12 IN-12 Nixie Tubes. Each compartment is 30.5mm x 20.5mm x 20mm in height.
Stanley Picks and Hooks Pegboard Holder
January 4, 2020
· admin
3D Printing
object
This is a simple holder for the set of 4 Picks and Hooks made by Stanley. It is designed for the north American pegboard. The holes are 1 inch (25.4 mm) apart.
Alligator Clip Cable Pegboard Holder (updated)
December 30, 2019
· admin
3D Printing
object
It can hold up to 20 alligator clip cables. It is designed to be used with a North American pegboard. The distance between the holes is 1 inch (2.54 cm). The hole diameter is 1/4 of an inch (6.35 mm).
Parametric Open Box
December 22, 2019
· admin
3D Printing
object
This is a simple SCAD file that generates simple open boxes without chamfers or fillets. They fit snuggly together. A sample is included. To create a custom one:
Ivar Side Unit Hook
December 16, 2019
· admin
3D Printing
object
This is a simple Ivar Side Unit hook. No additional hardware is required.
FLSun Cube Part Cooling Fan
December 2, 2019
· admin
3D Printing
object
This is a part cooling fan for the FlSun. The original design has only one fan that cools the extruder and the part at the same time but it doesn't do a good job.