2020 Extrusion Spool Holder
September 15, 2019
· admin
3D Printing
object
This spool holder is designed to fit a 2020 aluminum extrusion. It is a replacement for the FLSun Cube spool holder.
FLSun Cube Foot
September 8, 2019
· admin
3D Printing
object
This a part that is installed on the existing feet of the FLsun Cube. The stock feet made of aluminum damage the surface of the table on which the printer is installed. These will protect your work area.
FLSun Cube Bowden Tube Strain Relief
August 31, 2019
· admin
3D Printing
object
This is a Bowden tube strain relief for the FLsun Cube. It should be installed near the extruder.
Reprap Discount LCD Holder for 2020 extrusion
August 24, 2019
· admin
3D Printing
object
This Reprap Discount LCD holder has been specially designed for the FLSun Cube. This design lets you attach the display under a 2020 extrusion.
FLSun Cube X-Axis Belt Tensioner
August 18, 2019
· admin
3D Printing
object
The FLSun Cube 3D printer does not come with an X-Axis belt tensioner. So, I designed one. The design is simple but very effective.
FLSun Cube Bed Level Adjustment Tool
August 10, 2019
· admin
3D Printing
object
This is a simple tool to adjust the level of the bed of a FLSun Cube. Likely, it can be used with other printers such as the CR-10.
FLSun Cube Bed Cable Strain Relief
August 3, 2019
· admin
3D Printing
object
This is a strain relief for the heated bed cables of the FLSun Cube. A zip tie is used to fix it to the bed frame. I drilled a small hole to pass the zip tie through the bed frame.
FLSun Cube Extruder Cable Strain Relief/Holder i2
July 27, 2019
· admin
3D Printing
object
This is a strain relief for the wires and the PTFE tube attached to the extruder of the FLSun Cube 3D printer. It is installed using the bolts of 2 of the linear bearing holders. The M4x16 bolts will need to be replaced by M4x20 bolts. A zip tie is used to attach the wires and the PTFE tube.
2020 Extrusion Power Supply Stabilizer
July 21, 2019
· admin
3D Printing
object
This is a simple stabilizer for a power supply designed to be attached to a 2020 aluminum extrusion. This stabilizer is designed for the FLSun Cube. You will need an M3x8mm, M5x10mm, and a M5 T-NUT to install it.
FLSun Cube Extruder Cable Strain Relief/Holder
July 13, 2019
· admin
3D Printing
object
This is a strain relief for the wires and the PTFE tube attached to the extruder of the FLSun Cube 3D printer. It is installed using the bolts of 2 of the linear bearing holders. The M4x16 bolts will need to be replaced by M4x20 bolts. A zip tie is used to attach the wires and the PTFE tube.