Alligator Clip Cable Pegboard Holder (updated)

December 30, 2019 3D Printing object

Description

It can hold up to 20 alligator clip cables. It is designed to be used with a North American pegboard. The distance between the holes is 1 inch (2.54 cm). The hole diameter is 1/4 of an inch (6.35 mm).

The previous design has been updated. It is 3 mm narrower. So, multiple holders can be put side by side.

It can be printed without support.

This object was designed using Fusion 360

Files

Alligator-Clip-Cable-Holder.stl

This object is also published on the following site(s):

Thingiverse

Alligator Clip Cable Pegboard Holder (updated) (247)

You may request the source file(s) for this object by posting a comment below. Your email address will be used solely to deliver the requested source file(s) and for no other purpose.

By requesting the source file(s), you are granted permission to:

Share — Copy and redistribute the material, excluding the source file(s), in any medium or format.
Adapt — Remix, transform, and build upon the material.

By requesting the source file(s), you also agree to:

Give appropriate credit, provide a link to the license, and indicate whether changes were made. You may do so in any reasonable manner, provided that it does not suggest that the licensor endorses you or your use.
Not use the material for commercial purposes.
Distribute any derivative works under the same license as the original if you remix, transform, or build upon the material.
Not apply legal terms or technological measures that legally restrict others from exercising the rights granted by the license.
Not upload the source file(s) or any modified versions of the source file(s) to any website or file-sharing service.
The source file(s) are provided for your personal use only. However, you may freely upload and distribute any STL or OBJ files generated from the source file(s).

If you do not agree to all of these conditions, please do not request the source file(s).

Name

Comment

Do you agree to all these conditions?

This form cannot be submitted until 30 seconds have elapsed. You have time to read the conditions and fill out the form.

This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.

Alligator Clip Cable Pegboard Holder (updated)

Description

Files

This object is also published on the following site(s):

Leave a Comment