L'Antre du Tryphon

This is a stand for a Logitech C170 webcam with a magnetic base. Two heights are provided: 70 mm and 150 mm. It uses only the base a commonly available

TIL311 are single-digits LED hexadecimal displays with an internal four-bit latch and decoder along with the LED drivers. They come in 14 pins, dual-in-line-package. The characters are made of an

This is a privacy shield that you put on your Logitech C170 webcam in order to block the lens and thus to ensure your privacy. It is sturdier than the

This is a desk organizer holding pens, post-it, index cards, etc. Version with a side paper holder and one without it are provided. Also, the side paper holder is provided

This stand keeps a flashlight vertical. The allowed flashlight diameter is 32 mm. Support material is not required. An infill of 10% is recommended. This object was designed using Fusion

This is an anti-vibration foot for the Prusa i3 MK3S. It should be printed with TPU for best results. You will need to print 4 of these! Support material is

This is a 5-1/4 inch round speaker enclosure. The total speaker depth is 50 mm. The screw holes for the speaker are 141 mm diagonally. You’ll need 4 x M3

This is a set of thickness gauges. The supplied thickness are 1, 2, 4, 8, 16 and 32 mm. Thicknesses from 1 up to 63 mm may be achieved by

This is a small caddy to hold up to 6 soldering iron tips, up to 3 spools of solder wire and a tip cleaner. The tip cleaner has a diameter

This is a stand when used with some DIN Rails makes a useful electronic prototyping rig. You will be able to move your prototypes easily with it. Feet are also

This is a tray system to be installed on the stand of an ASUS VA32A monitor. You will need to print one small drawer and 2 large drawers. Two models

This is a simple white board shelf for the cleaning supplies. The first holder is 9.5 cm in diameter. The second holder is 6 cm in diameter. Two 5 mm

This is a modular Single Board Computers enclosure for up to 4 devices. The device cards are held vertically. This design let you service one card without having to remove

This simple white board organizer can hold 6 markers along with the eraser. This new design is thinner and have an opening at the bottom that lets you see the

This is a tray that holds up to 8 Wera micro screwdrivers. The design will hold the screwdriver labels upright. Multiple trays may be stacked. Support material is required for

I’ve tested 3 different Raspberry Pi used as firewalls at measured the performance I was getting. The Raspberry Pis are: Model 2B, rev 1.1 (a01041) with a BCM2835 processor, 1

This object is a simple micro SD card carrier having the same size as an SD card. It was designed to put a micro SD card into a SD card

My small personal photo album is back online. The main gallery of this photo album is Maquettes. It contains a few pictures of the models, my father, Paul-Émile Théroux built

This is a minimalist case for a Raspberry Pi 1B+, 2 or 3. Why another case when there are so many out there? This one has the smallest footprint. Most

This is a stand when used with some DIN Rails makes a useful electronic prototyping rig. You will be able to move your prototypes easily with it. Feet are also