Bambu Lab Top LED Strip

February 17, 2024 3D Printing object

Description

This is an object that holds LED strips to be installed on the top glass of a Bambu Lab printer. Even if the light goes through the top glass, it adds enough light to improve significantly the visibility in the chamber. The goal of this design is to be simple and non-intrusive.

You'll need four riser foot to raise the AMS unit, two pieces of LED strip of less than 1 cm wide, electrical wire and a source of power.

You may need to mirror one of the LED Canopy Holder Braces, so the wire will exit the brace on the side you want. The LED canopy will fit on the Bambu Lab bed if printed diagonally.

Support material touching the bed plate is required only for the pins that goes into the braces. An infill of 20% is recommended.

This object was designed using Solid Edge Community Edition.

Files

	LedCanopy.stl
	LedCanopyHolder.stl
	AMSRiserFeet-1.stl

This object is also published on the following site(s):

Bambu Lab Top LED Strip (397)

You may request the source file(s) for this object by posting a comment below. Your email address will be used solely to deliver the requested source file(s) and for no other purpose.

By requesting the source file(s), you are granted permission to:

Share — Copy and redistribute the material, excluding the source file(s), in any medium or format.
Adapt — Remix, transform, and build upon the material.

By requesting the source file(s), you also agree to:

Give appropriate credit, provide a link to the license, and indicate whether changes were made. You may do so in any reasonable manner, provided that it does not suggest that the licensor endorses you or your use.
Not use the material for commercial purposes.
Distribute any derivative works under the same license as the original if you remix, transform, or build upon the material.
Not apply legal terms or technological measures that legally restrict others from exercising the rights granted by the license.
Not upload the source file(s) or any modified versions of the source file(s) to any website or file-sharing service.
The source file(s) are provided for your personal use only. However, you may freely upload and distribute any STL or OBJ files generated from the source file(s).

If you do not agree to all of these conditions, please do not request the source file(s).

Name

Comment

Do you agree to all these conditions?

This form cannot be submitted until 30 seconds have elapsed. You have time to read the conditions and fill out the form.

This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.