L'Antre du Tryphon

This is a magnetic mount for Logitech webcams C170 and C270. Besides the printed parts, you will need one M4 x 10 mm screw, one M3 x 12 mm screw

This is a clip to hold flat cables against a 2020 extrusion. It protects the flat cable against damages that may be done by zip ties. You will need a

This is a TPU anti-vibration foot for 2020 aluminum extrusion. It was designed for 1610 and 3018 CNCs but obviously can be used for other purposes. It should be printed

These are a wide and a long nose nozzles for a Rigid Gen5X Brushless 18V Wet/Dry Vacuum. The previous wide nozzle design has been improved significantly. The internal diameter is

This openSCAD model generates a box that can be attached using 2 screws on a wall, aluminum extrusion, etc. They can be offsetted from the center of the box if

This is a cap to protect a CNC bed from widely avalaible clamp damages. Support material is not required. An infill of 100% is recommended. This object was designed using

This is a parametric modular storage system designed to organize an office drawer. Its main design goal was to be able to have 2 layers of storage in a drawer

This project contains 5 improvements for a 1610 CNC. These improvements were inspired by the following YouTube videos of JJ Hontebeyrie: https://www.youtube.com/watch?v=NNrqx62lyBI&t=602s https://www.youtube.com/watch?v=_gX_YCsN4wo 1. Extrusion slot covers I’ve used the

This is a simple guide that strengthen the PTFE tube at the extruder output of a TronXY X5SA printer. You will need a M4 x 12 mm screw along with

This is a large background holder designed for photography. It can hold a cardboard up to 0.6 mm tick. This is a big object. Your printer bed must be at

This is a privacy shield that you put on your Logitech C270 webcam in order to block the lens and thus to ensure your privacy. Support material isn’t required. An

This is a tripod adapter for a Google Pixel 6 Pro phone including its protective case. You will need a 1/4 of a inch nut that has 11 mm between

This is a spacer for the filament run out sensor of the TronXY X5SA. It straighten the filament between the sensor and the extruder. You will need to replace the

This is a stand for a Logitech C170 webcam with a magnetic base. Two heights are provided: 70 mm and 150 mm. It uses only the base a commonly available

This is a privacy shield that you put on your Logitech C170 webcam in order to block the lens and thus to ensure your privacy. It is sturdier than the

This is a desk organizer holding pens, post-it, index cards, etc. Version with a side paper holder and one without it are provided. Also, the side paper holder is provided

This stand keeps a flashlight vertical. The allowed flashlight diameter is 32 mm. Support material is not required. An infill of 10% is recommended. This object was designed using Fusion

This is an anti-vibration foot for the Prusa i3 MK3S. It should be printed with TPU for best results. You will need to print 4 of these! Support material is

This is a 5-1/4 inch round speaker enclosure. The total speaker depth is 50 mm. The screw holes for the speaker are 141 mm diagonally. You’ll need 4 x M3

This is a set of thickness gauges. The supplied thickness are 1, 2, 4, 8, 16 and 32 mm. Thicknesses from 1 up to 63 mm may be achieved by