DIN Rail Prototyping Stand V02

August 28, 2021 3D Printing object

Description

This is a stand when used with some DIN Rails makes a useful electronic prototyping rig. You will be able to move your prototypes easily with it. Feet are also provided to tilt a bit the stand (15 degrees). You will find on Thingiverse or Printables many accessories. Search for DIN Rail.

M4 nuts and bolts are recommended for assembly. You will need 2 x 8 mm and 2 x 16 mm bolts if you are using the feet. Otherwise, 4 x 8 mm will be required.

You will need to print 2 of each. Minimal support material touching the plate is needed for the rail holders. Print them upright. None is required for the risers. An infill of 20% is recommended.

This object was designed using Solid Edge Community Edition.

Files

	StandV02.stl
	StandV02Riser.stl

This object is also published on the following site(s):

DIN Rail Prototyping Stand V02 (290)

You may request the source file(s) for this object by posting a comment below. Your email address will be used solely to deliver the requested source file(s) and for no other purpose.

By requesting the source file(s), you are granted permission to:

Share — Copy and redistribute the material, excluding the source file(s), in any medium or format.
Adapt — Remix, transform, and build upon the material.

By requesting the source file(s), you also agree to:

Give appropriate credit, provide a link to the license, and indicate whether changes were made. You may do so in any reasonable manner, provided that it does not suggest that the licensor endorses you or your use.
Not use the material for commercial purposes.
Distribute any derivative works under the same license as the original if you remix, transform, or build upon the material.
Not apply legal terms or technological measures that legally restrict others from exercising the rights granted by the license.
Not upload the source file(s) or any modified versions of the source file(s) to any website or file-sharing service.
The source file(s) are provided for your personal use only. However, you may freely upload and distribute any STL or OBJ files generated from the source file(s).

If you do not agree to all of these conditions, please do not request the source file(s).

Name

Comment

Do you agree to all these conditions?

This form cannot be submitted until 30 seconds have elapsed. You have time to read the conditions and fill out the form.

This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.

DIN Rail Prototyping Stand V02

Description

Files

This object is also published on the following site(s):

Leave a Comment