Ender-3 Y-axis Endstop Holder

November 25, 2018 3D Printing object

Description

The Y-Axis must be moved if a motor damper is installed. Otherwise, the carriage will hit the motor. The original Y-axis end stop holder is designed to use M4 screws. This replacement allows M5 screws along with M5 T-Nuts to be used to mount the end top at the proper location.

This object was designed using Fusion 360

Files

Ender-3-Y-axis-Endstop-Holder.stl

This object is also published on the following site(s):

Thingiverse

Ender-3 Y-axis Endstop Holder (201)

You may request the source file(s) for this object by posting a comment below. Your email address will be used solely to deliver the requested source file(s) and for no other purpose.

By requesting the source file(s), you are granted permission to:

Share — Copy and redistribute the material, excluding the source file(s), in any medium or format.
Adapt — Remix, transform, and build upon the material.

By requesting the source file(s), you also agree to:

Give appropriate credit, provide a link to the license, and indicate whether changes were made. You may do so in any reasonable manner, provided that it does not suggest that the licensor endorses you or your use.
Not use the material for commercial purposes.
Distribute any derivative works under the same license as the original if you remix, transform, or build upon the material.
Not apply legal terms or technological measures that legally restrict others from exercising the rights granted by the license.
Not upload the source file(s) or any modified versions of the source file(s) to any website or file-sharing service.
The source file(s) are provided for your personal use only. However, you may freely upload and distribute any STL or OBJ files generated from the source file(s).

If you do not agree to all of these conditions, please do not request the source file(s).

Name

Comment

Do you agree to all these conditions?

This form cannot be submitted until 30 seconds have elapsed. You have time to read the conditions and fill out the form.

This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.

Comments

Cristóbal González September 28, 2025

Hello! I would like to obtain the source file for Fusion 360 to add compatibility for M6 screws.

ctheroux October 16, 2025

Hi, you will receive shortly an email with the source file. Regards.

Ender-3 Y-axis Endstop Holder

Description

Files

This object is also published on the following site(s):

Comments

Leave a Comment