Fluval Flex 15 Gallons Light Replacement

June 4, 2022 3D Printing object

Description

This is a light replacement for a Fluval Flex 15 gallons aquarium. You will need a strip of WRBG LEDs. I suggest you to reuse the supplied LED controller. I've used some epoxy glue to seal the lens to the base and the wires to make it water tight. The lenses are best printed vertically. This light fixture is held using 2 thin holders using the 2 original screws. You will also need a soldering iron, some wires and shrink tubing to assemble the electronics to the LED strip.

Support material is not required. An infill of 20% is recommended.

This object was designed using Solid Edge Community Edition.

Files

	LedBase.stl
	LensOpenSide.stl
	LensClosedSide.stl
	ThinHolder.stl
	LedBase.stl
	LensOpenSide.stl
	LensClosedSide.stl
	ThinHolder.stl

This object is also published on the following site(s):

The source files are available

You may request the source file(s) for this object by posting a comment below. Your email address will be used solely to deliver the requested source files and for no other purpose.

By requesting the source files, you are granted permission to:

Share — Copy and redistribute the material, excluding the source files, in any medium or format.
Adapt — Remix, transform, and build upon the material.

By requesting the source files, you also agree to:

Give appropriate credit, provide a link to the license, and indicate whether changes were made. You may do so in any reasonable manner, provided it does not suggest that the licensor endorses you or your use.
Not use the material for commercial purposes.
Distribute any derivative works under the same license as the original if you remix, transform, or build upon the material.
Not apply legal terms or technological measures that legally restrict others from exercising the rights granted by this license.
Not upload the source files or modified versions of the source files to any website or file-sharing service. They are provided for your personal use only. However, you may freely upload and distribute any STL or OBJ files generated from them.

If you do not agree to all of these conditions, please do not request the source files.