Ikea Skogsta Screwdriver Holders

 

These are screwdriver holders for the Ikea Skogsta tool box. One can hold four screwdrivers. The holes are 40 mm apart from each other. This holder is designed to be placed on the right side. The one designed for the left side can hold four screwdrivers, 30 mm apart from each other. The center one can hold three screws drivers, 35 mm and 30 mm apart from each other.

Holes for the tools are 10 mm in diameter.

The spacers are used to lift tools that are longer so they do not touch the surface where the tool box sits. Use some hot glue to attach them to the screwdriver holders.

The sides are 1.5 mm thick. Print the bins upright with 100% infill along with support.

This object was designed using Fusion 360


Printable Files

 Screw Driver Holder 4cm
 
 Screw Driver Holder 3cm – 3 holes
 
 Screw Driver Holder 3cm – 4 holes
 
 Long Tool Spacer 20 mm
 
 Long Tool Spacer 40 mm
 

This object is also published on the following site(s):
Thingiverse


The source files are available:

You may request the source file(s) of this object. Ask for it by posting a comment below. Your email address will NOT be used for any other purposes than delivering you the source files. By doing so:

You are free to:

* Share — copy and redistribute the material except the source files in any medium or format
* Adapt — remix, transform, and build upon the material

You agree to:

* give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
* not use the material for commercial purposes
* distribute your contributions under the same license as the original if you remix, transform, or build upon the material
* not apply legal terms or technological measures that legally restrict others from doing anything the license permits.
* not upload the source files or modified source files on any sites. They are made available for your personal usage only. Nevertheless, you are allowed to upload the resulting STL or OBJ files.

If you do not agree to any of these conditions, do NOT request the source files.


Copyright 2012-2020 by Claude “Tryphon” Théroux

Leave comment

Your email address will not be published. Comments are moderated before they are published. Required fields are marked with *.

Time limit is exhausted. Please reload the CAPTCHA.