Magazine File
October 24, 2020
3D Printing
object
Description
This is a magazine file 60 mm wide. It is designed for letter size paper. It is by design a bit smaller than the document it holds. It has holes to mount it on the side of a desk.
Support is not needed.
This object was designed using Solid Edge Community Edition.
Files
|
MagazineFile.stl |
|
|
MagazineFile.pdf |
This object is also published on the following site(s):
This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.
Copyright 2012–2026, Claude "Tryphon" Théroux
Leave a Comment