Mini Solder Spool

May 2, 2020 3D Printing object

Description

Soldering electronic components using a large solder spool of 454 grams or so is quite inconvenient even if it is mounted on a solder spool holder. I prefer to wind a small amount of it on a smaller spool. This is what this mini solder spool is for. It can hold about 75 grams of solder wire.

Print one of each part and screw them together. You can use an electric drill at low speed to wind some solder wire on the spool. A bit of advice, use a small tube to guide the solder on the spool. Do not use your fingers especially if the solder contains lead.

I suggest using at least 30% infill.

Support is not needed.

This object was designed using Fusion 360

Files

	Mini-Solder-Spool-Base.stl
	Mini-Solder-Spool-Nut.stl

This object is also published on the following site(s):

Thingiverse

The source files are available

You may request the source file(s) for this object by posting a comment below. Your email address will be used solely to deliver the requested source files and for no other purpose.

By requesting the source files, you are granted permission to:

Share — Copy and redistribute the material, excluding the source files, in any medium or format.
Adapt — Remix, transform, and build upon the material.

By requesting the source files, you also agree to:

Give appropriate credit, provide a link to the license, and indicate whether changes were made. You may do so in any reasonable manner, provided it does not suggest that the licensor endorses you or your use.
Not use the material for commercial purposes.
Distribute any derivative works under the same license as the original if you remix, transform, or build upon the material.
Not apply legal terms or technological measures that legally restrict others from exercising the rights granted by this license.
Not upload the source files or modified versions of the source files to any website or file-sharing service. They are provided for your personal use only. However, you may freely upload and distribute any STL or OBJ files generated from them.

If you do not agree to all of these conditions, please do not request the source files.