Parametric Can Stacking Spacers

February 22, 2025 · claude 3D Printing

Description

These spacers let you stack can of food easily. You can customize them using openSCAD. Take a copy of CanStackingDisks_Parameters.scad and update the parameters. Open the file with openSCAD and Use F5, F6 and F7 to create the related STL file. The diameter of the spacer should be 5 mm smaller than the diameter of the can.

Support material is not required. An infill of 20% is recommended.

This object was designed using openSCAD.

Files

	CanStackingDisks_6cm_x_7mm.stl
	CanStackingDisks_8cm_x_7mm.stl
	CanStackingDisks_9.5cm_x_7mm.stl
	CanStackingDisks_Parameters.scad
	CanStackingDisks.scad

This object is also published on the following site(s):

Thingiverse
Printables
MakerWorld

This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.

Parametric Can Stacking Spacers

Description

Files

This object is also published on the following site(s):

Leave a Comment