Parametric Device Holder
September 23, 2023 · claude
3D Printing
Description
This is a parametric device holder for square devices. Options are provided for screw mounting holes. By adjusting the parameters will make it fit any square devices. Three practical examples are given.
Support material is required. An infill of 20% is recommended.
This object was designed using openSCAD.
Files
|
ParametricDeviceHolder.scad |
|
|
Orico-7-Port-USB-3.0-HUB-Model-H7013-U3.stl |
|
|
TP-Link-USB-3.0-7-Port-Hub-with-2-Charging-Ports-Model-UH720.stl |
|
UGREEN-USB-3.0-Sharing-Switch-Model-30768.stl |
This object is also published on the following site(s):
This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.
Copyright 2012–2026, Claude "Tryphon" Théroux
Leave a Comment