Parametric Washer
June 14, 2025
3D Printing
object
Description
This is a simple parametric washer.
Support material is not required. An infill of 30% is recommended.
This object was designed using openSCAD.
Files
|
|
SampleWasher.stl |
|
ParametricWasher.scad |
This object is also published on the following site(s):
This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.
Copyright 2012–2026, Claude "Tryphon" Théroux
Leave a Comment