Pen Holder V05

June 30, 2023 3D Printing object

Description

This is another variation of the pen holder published previously. This one is the largest. It can hold about 64 pens. The top part of it is modular. It can be redesigned and printing the whole pen holder is not required. The current version can hold sticky notes, rulers, etc. The U shape part is used to raise the second section of the top. It is not mandatory to use it.

Support material is not required. An infill of 20% is recommended.

This object was designed using Solid Edge Community Edition.

Files

	PenHolderV05.stl
	TopInsert.stl
	TopInsertRiser.stl

This object is also published on the following site(s):

Pen Holder V05 (370)

You may request the source file(s) for this object by posting a comment below. Your email address will be used solely to deliver the requested source file(s) and for no other purpose.

By requesting the source file(s), you are granted permission to:

Share — Copy and redistribute the material, excluding the source file(s), in any medium or format.
Adapt — Remix, transform, and build upon the material.

By requesting the source file(s), you also agree to:

Give appropriate credit, provide a link to the license, and indicate whether changes were made. You may do so in any reasonable manner, provided that it does not suggest that the licensor endorses you or your use.
Not use the material for commercial purposes.
Distribute any derivative works under the same license as the original if you remix, transform, or build upon the material.
Not apply legal terms or technological measures that legally restrict others from exercising the rights granted by the license.
Not upload the source file(s) or any modified versions of the source file(s) to any website or file-sharing service.
The source file(s) are provided for your personal use only. However, you may freely upload and distribute any STL or OBJ files generated from the source file(s).

If you do not agree to all of these conditions, please do not request the source file(s).

Name

Comment

Do you agree to all these conditions?

This form cannot be submitted until 30 seconds have elapsed. You have time to read the conditions and fill out the form.

This project is distributed under the Creative Commons - Attribution - Non-Commercial - Share Alike (CC-BY-NC-SA) license.

Pen Holder V05

Description

Files

This object is also published on the following site(s):

Leave a Comment