Two spools Holder
Description
This is a two (2) filament spools holder. It can easily extended for more than two (2) spools.
Print:
- 2 x top-support.stl
- 2 x middle-support.stl
- 4 x Prusa i3 spool holder middle bar.stl
- 2 x 8 mm rod filament guides
To assemble it as shown on the pictures, you will need:
- to print 2 universal spool bushing
- optionally 4 x 608ZZ bearing model (if you do not use real bearings)
- 4 x 608ZZ bearings or bushings
- 16 x 5/16″ or 8 mm washers
- 16 x 5/16″ or 8 mm nuts
- 2 x 16″ (40 cm) 5/16″ or 8 mm rods
- 2 x 10″ (26 cm) 5/16″ or 8 mm rods
- 2 x 6″1/4 (16 cm) 5/16″ or 8 mm rods
Adapt the rod lengths if needed. The filament guides must be positioned perpendicularly to the natural filament direction. Otherwise, it might add some unwanted friction.
You will also need some vitamins to build the base of the holder.
Printable Files
120709_Universal_Spool_Bushing | |
120709_top-support | |
120709_Prusa_i3_spool_holder_middle_bar | |
120709_middle-support | |
120709_Filament_Guide_For_8_mm_Rod | |
120709_608ZZ_Bearing_Model |
Copyright 2012-2013 by Claude Théroux