ctheroux.com

Desiccant Spool Tumbler Add-ons

December 30, 2023 · claude 3D Printing object

These are two add-ons for the Desiccant Spool Tumbler designed by chuyskywalker (https://www.printables.com/model/436044-desiccant-spool-tumbler). I like the design. I'm constantly using them. A funnel is provided to fill them out with desiccant. The...

Parametric Funnel

December 27, 2023 · claude 3D Printing object

This is a parametric funnel with optional hanging loop and angled stem.

Bambu Lab AMS Cardholder

November 24, 2023 · claude 3D Printing object

This is a device that holds cards that identify the filament loaded in the Bambu Lab AMS unit. The size of the cards are 42.3 mm x 76 mm which corresponds to a 1/3 of a 5 x 3 inches index card. The numbers are highlighted using a Sharpie. A template...

DIN Rail Arduino Uno and Mega Mounts

November 10, 2023 · claude 3D Printing object

These are din rail mounts for an Arduino Uno and Mega 2560 or any board that has these form factors. The din rail clip can be attached temporarily to the Arduino base using a piece of 1.75 mm filament. The clip can be attached horizontally or...

Din Rail Breadboard Mounts

October 28, 2023 · claude 3D Printing object

These are din rail breadboard mounts for 400 and 830 points breadboards. The din rail clips can be attached temporarily to the breadboard base using a piece of 1.75 mm filament. The clips can be attached horizontally or vertically to the breadboard...

Chromatography Container

October 21, 2023 · claude 3D Printing object

This is a small chromatography container. It can hold paper up to 5 cm in width, from 50 mm to 120 mm in length. The length given in the filename is the maximum length of the paper supported.

Bambu Lab Magnetic Poop Container

October 13, 2023 · claude 3D Printing object

This is another Bambu Lab Magnetic Poop Container. It fits the P1P, P1S and the X1 series. Magnet up to 12 mm in diameter can be used. Their thickness can be 2 mm, 3 mm and/or 4 mm. Up to 4 magnets of each size can be used. Usually 2 of them is...

Parametric Foot

October 6, 2023 · claude 3D Printing object

This openSCAD script create feet for projects. It was designed for aluminum extrusion, but can be used for other purposes. The thickness of the sides will have an impact on vibration dampening. TPU is recommended. The given example is for 20 x 20 mm...

Arbitrarily Compartmented Box With Overlapped Lid

September 29, 2023 · claude 3D Printing object

This is a parametric compartmented box with overlapped lib. The example is a box that contains electronic boards in small bags.

Spools compatible with the Bambu Lab AMS

September 28, 2023 · claude 3D Printing

This post lists the spools compatible with the Bambu Lab AMS. I've used them.

Tags