ctheroux.com

Parametric Funnel

December 28, 2023 · admin 3D Printing object

This is a parametric funnel with optional hanging loop and angled stem.

Bambu Lab AMS Cardholder

November 25, 2023 · admin 3D Printing object

This is a device that holds cards that identify the filament loaded in the Bambu Lab AMS unit. The size of the cards are 42.3 mm x 76 mm which corresponds to a 1/3 of a 5 x 3 inches index card. The numbers are highlighted using a Sharpie. A template that let you print 3 cards per index card is also include.

DIN Rail Arduino Uno and Mega Mounts

November 11, 2023 · admin 3D Printing object

These are din rail mounts for an Arduino Uno and Mega 2560 or any board that has these form factors. The din rail clip can be attached temporarily to the Arduino base using a piece of 1.75 mm filament. The clip can be attached horizontally or vertically to the Arduino base. It can also be glued to the Arduino base for a permanent setup. The clip shall be printed on its side. The spacers shall be put between the base and the Arduino board, held by the screws. Four or six M2.5 x 8 mm screws are required, but may be substituted.

Din Rail Breadboard Mounts

October 28, 2023 · admin 3D Printing object

These are din rail breadboard mounts for 400 and 830 points breadboards. The din rail clips can be attached temporarily to the breadboard base using a piece of 1.75 mm filament. The clips can be attached horizontally or vertically to the breadboard base. They can also be glued to the breadboard base for a permanent setup. Clips shall be printed on their side. The 830 points Breadboard base needs two clips.

Chromatography Container

October 21, 2023 · admin 3D Printing object

This is a small chromatography container. It can hold paper up to 5 cm in width, from 50 mm to 120 mm in length. The length given in the filename is the maximum length of the paper supported.

Bambu Lab Magnetic Poop Container

October 14, 2023 · admin 3D Printing object

This is another Bambu Lab Magnetic Poop Container. It fits the P1P, P1S and the X1 series. Magnet up to 12 mm in diameter can be used. Their thickness can be 2 mm, 3 mm and/or 4 mm. Up to 4 magnets of each size can be used. Usually 2 of them is enough.

Parametric Foot

October 7, 2023 · admin 3D Printing object

This openSCAD script create feet for projects. It was designed for aluminum extrusion, but can be used for other purposes. The thickness of the sides will have an impact on vibration dampening. TPU is recommended. The given example is for 20 x 20 mm extrusion using a M5 bolt.

Arbitrarily Compartmented Box With Overlapped Lid

September 30, 2023 · admin 3D Printing object

This is a parametric compartmented box with overlapped lib. The example is a box that contains electronic boards in small bags.

Parametric Device Holder

September 23, 2023 · admin 3D Printing object

This is a parametric device holder for square devices. Options are provided for screw mounting holes. By adjusting the parameters will make it fit any square devices. Three practical examples are given.

Bambu Lab P1P/P1S Screen Removal Tool

September 16, 2023 · admin 3D Printing object

This is a simple tool that helps to remove the screen of a Bambu Lab P1P or P1S. Removing the screen after it was installed is a bit difficult. This tool prevents you from pushing on the screen itself. Use this tool to push the base of the screen to the right. This tool can be easily adapted for another purpose, since it is parametric.

Tags