ctheroux.com

Bambu Lab P1P/P1S Screen Removal Tool

September 16, 2023 · admin 3D Printing object

This is a simple tool that helps to remove the screen of a Bambu Lab P1P or P1S. Removing the screen after it was installed is a bit difficult. This tool prevents you from pushing on the screen itself. Use this tool to push the base of the screen to the right. This tool can be easily adapted for another purpose, since it is parametric.

Parametric Clickable Stamps Holder

July 28, 2023 · admin 3D Printing object

Parametric Clickable Stamp Holder. It fit out of the box, the stamps distributed by Michaels'. The item numbers of these stamps are 10656553 and 10656558. Holder for 3 to 9 stamps are included as the base set. You can customize the holder to fit any stamps and number as long as they're square using openSCAD. Using

Ikea Ivar Caliper and Folding Ruler holder

July 22, 2023 · admin 3D Printing object

This is a holder for a Caliper and Folding Ruler for the Ikea Ivar. It is designed for the side units. The width of the folding ruler is 1.6 cm. The width of the caliper with its case is 2.8 cm.

Parametric Clickable Stamp Case

July 16, 2023 · admin 3D Printing object

This is a parametric clickable stamps case. It fit out of the box the stamps distributed by Michaels'. The item numbers of these stamps are 10656553 and 10656558.

Triple 5mA battery trickle charger

July 8, 2023 · admin 3D Printing object

Triple 5mA battery trickle charger --------------------------------------------------------------------------------

Pen Holder V05

June 30, 2023 · admin 3D Printing object

This is another variation of the pen holder published previously. This one is the largest. It can hold about 64 pens. The top part of it is modular. It can be redesigned and printing the whole pen holder is not required. The current version can hold sticky notes, rulers, etc. The U shape part is used to raise the second section of the top. It is not mandatory to use it.

Parametric Container with an overlapped lid

June 25, 2023 · admin 3D Printing object

This is a parametric container with an overlapped lid.

8 ml Inkwell

June 10, 2023 · admin 3D Printing object

This is a small 8 ml inkwell design to be used to refill a fountain pen. Test it with water before putting ink in it. Printing parameters may prevent it from being water tight.

Parametric Stamp Handle

April 29, 2023 · admin 3D Printing object

This is a parametric stamp handle. It works pretty well with silicon stamps. I've used superglue to attach the stamp to the handle. A sample STL file is provided. Use OpenSCAD to create one that fits the dimensions you need.

Simple human interface for Home Assistant

April 22, 2023 · admin Hardware 3D Printing object automation ESP8266 NodeMCU IoT Internet of Things Electronic Component

This is a simple human interface project for Home Assistant. It helps me remind doing 2 daily tasks. Using Home Assistant automation, it lit a LED at a given time and use the corresponding button to reset it when I'm done.

Tags