5-1/4 inch round speaker enclosure
December 25, 2021
· admin
3D Printing
object
This is a 5-1/4 inch round speaker enclosure. The total speaker depth is 50 mm.
Thickness Gauges
December 18, 2021
· admin
3D Printing
object
This is a set of thickness gauges. The supplied thickness are 1, 2, 4, 8, 16 and 32 mm. Thicknesses from 1 up to 63 mm may be achieved by combining some supplied ones.
Soldering Accessories Caddy
December 11, 2021
· admin
3D Printing
object
This is a small caddy to hold up to 6 soldering iron tips, up to 3 spools of solder wire and a tip cleaner.
Large DIN Rail Prototyping Stand
December 4, 2021
· admin
3D Printing
object
This is a stand when used with some DIN Rails makes a useful electronic prototyping rig. You will be able to move your prototypes easily with it. Feet are also provided to tilt a bit the stand (15 degrees). You will find on Thingiverse many accessories. Search for DIN Rail.
ASUS VA32A Monitor Tray System
November 27, 2021
· admin
3D Printing
object
This is a tray system to be installed on the stand of an ASUS VA32A monitor.
White Board Cleaners Shelf
November 20, 2021
· admin
3D Printing
object
This is a simple white board shelf for the cleaning supplies. The first holder is 9.5 cm in diameter. The second holder is 6 cm in diameter. Two 5 mm mounting screw holes are provided.
SBC Server Case V2
November 13, 2021
· admin
3D Printing
object
This is a modular Single Board Computers enclosure for up to 4 devices. The device cards are held vertically. This design let you service one card without having to remove the cards on top of it like in the previous design (https://www.thingiverse.com/thing:4700165). This new design can still hold up to 4 cards containing Raspberry Pi, Arduino's, ESP32, hard drives, etc. My server case contains a firewall, a DNS and DHCP server and my IOT management system.
White Board Organizer V2
November 6, 2021
· admin
3D Printing
object
This simple white board organizer can hold 6 markers along with the eraser.
Wera Micro Screwdriver Stackable Tray
October 23, 2021
· admin
3D Printing
object
This is a tray that holds up to 8 Wera micro screwdrivers. The design will hold the screwdriver labels upright. Multiple trays may be stacked. Support material is required for the corners. An infill of 20% is recommended.
What performance to expect using a Raspberry Pi as a firewall?
October 2, 2021
· admin
Raspberry PI
Raspbian
RaspberryPI
Router
Firewall
I've tested 3 different Raspberry Pi used as firewalls at measured the performance I was getting. The Raspberry Pis are: