ctheroux.com

LG 27EA33 Storage Trays

February 21, 2021 · admin 3D Printing object

This is a tray designed to be installed on the stand of an LG 27EA33 monitor. You need to print the STL file provided and the same file mirrored. You will then need to glue them together.

Panavise 303 replacement pads

January 25, 2021 · admin 3D Printing object

These are replacement pads for the Panavise 303 vise. It has groves to hold tubular objects. I've printed it in semi-flexible filament, but works fine printed in PLA.

SBC Server Case

December 28, 2020 · admin 3D Printing object

This is a modular SBC or Development Board enclosure. Its base design principle is you stack on top of each other plates that hold various devices such as Raspberry PI, Arduinos, ESP32, hard drives, etc. You can customize it the way you like. You may need some plates not provided yet. Feel free to contact me if some plates are needed.

3.5 inch Hard Drive Box

November 8, 2020 · admin 3D Printing object

This is a box for a 3.5 inch hard drive and its cover. It was specifically designed to fit in a small safety box often rented by banks.

Electronic Bench Organizer

November 1, 2020 · admin 3D Printing object

This is an organizer especially designed for an electronic bench to hold small parts, screws, etc.

Magazine File

October 25, 2020 · admin 3D Printing object

This is a magazine file 60 mm wide. It is designed for letter size paper. It is by design a bit smaller than the document it holds. It has holes to mount it on the side of a desk.

CR-10 Under Bed Tray

October 18, 2020 · admin 3D Printing object

These are trays to put under a CR-10 3D printer. The separator of one tray are 15 mm in height. For the other one, 38 mm in height which is the total height of the tray. The overall size of both trays are the same.

Hanging Open Box

October 12, 2020 · admin 3D Printing object

This is an open box that can be hanged using 2 screws. The diameter of the head of the screw must be less than 1 cm. Its dimensions are 100 mm wide, 100 mm in height and 60 mm depth.

3D Printing Trashcan

September 27, 2020 · admin 3D Printing object

This is a small trashcan for 3D printing. The way the cover is designed, plastic stuff in the trashcan won't spring back outside it. The trashcan is 80 mm in diameter, 100 mm in height.

Parametric Round Container

July 13, 2020 · admin 3D Printing object

It is a simple parametric round container.

Tags