ctheroux.com

Parametric Bumper Feet

April 10, 2020 · admin 3D Printing object

This is a simple OpenSCAD project that generates bumper feet for various objects. It was specifically designed to replace the lost bumper feet of a Falcon Print Trimmer. Printing it using TPU is the best way to go. A sample is included. To create a custom one:

Nuvistor Display Stand

April 4, 2020 · admin 3D Printing object

This is a display stand for an old electronic part: the Nuvistor which is a type of vacuum tube. It was announced by RCA in 1959.

ESP8266 Motion Sensor Case

March 28, 2020 · admin 3D Printing object

This is a case for a motion sensor based on the ESP8266 and the HC-SR501, a PIR (motion) sensor.

4 inches x 0.7 inches Label Holder

March 21, 2020 · admin 3D Printing object

This is a paper tag holder made out of 4 inches (10.1 cm) x 3 inches (7.6 cm) index cards. They fit an edge of about 1/4 (6.25 mm) of an inch wide. A piece of size 4 inches (10.1 cm) x 0.7 (1.75 cm) inch out of the index card fits well.

Hanging Buckets for Power Supplies

March 14, 2020 · admin 3D Printing object

This kit of objects is two hanging buckets set for a cheap bench power supply. One bucket is 100 mm deep. The other is 50 mm deep. They are held together by two arms that you must glue to the buckets. The buckets are 84 mm apart.

Ikea Bror Caster Holder

March 7, 2020 · admin 3D Printing object

This object lets you install casters to a Bror workbench. It is designed for 1-7/8" (48.5 mm) x 2-9/16" (65.5 mm) casters. The holes for the bolts are 2-1/8" (54 mm) x 1" (25 mm) apart. The bolts I used are 1/4" (6.25 mm) in diameter, 1/2" (12.5 mm) long.

Ikea Ivar Vesa 100mm Mount

February 29, 2020 · admin 3D Printing object

This is a 100 mm VESA mount designed to be mounted on the Ikea Ivar side units. As shown on the picture, I have used it to mount a small monitor.

Ivar Side Unit Pin Hook

February 23, 2020 · admin 3D Printing object

This is a small pin design to hang stuff on the vertical post of Ikea Ivar side units. The pin is 3mm in diameter, 10 mm long.

Zip Tie Sleeves for the Ivar System

February 17, 2020 · admin 3D Printing object

This is a sleeve for Zip Ties. Its main utility is to protect the vertical supports of the Ikea Ivar system when using Zip Ties to attach stuff. They support zip ties up to 5 mm wide.

EN-EL10 Battery Tray

January 18, 2020 · admin 3D Printing object

This is two battery tray design for the EN-EL10 batteries. They are used by Nikon for their point and shoot cameras. One of the design holds 6 batteries while the other one holds 4 batteries at an angle for a lower overall height.

Tags