ctheroux.com

Thermometer Mounting Brackets

November 4, 2018 · admin 3D Printing object

This is a mounting bracket for a small thermometer. You can buy it on AliExpress for about $1.00. I use it to monitor the temperature inside the enclosure of my FLSun QQ (https://www.thingiverse.com/thing:3165164). Holes are provided to screw it to something. Nevertheless, I used hot glue to mount it on my FLSun QQ. The hole in the bracket is 26 mm x 45 mm.

3D Printing Tool Caddy

October 28, 2018 · admin 3D Printing object

Yes, another 3D Printing Tool Caddy! It contains only the essential tools. It can hold:

FLsun QQ Enclosure

October 21, 2018 · admin 3D Printing object

The way the FLsun QQ is designed makes it easy to enclose it. Printing ABS is possible with this enclosure.

Ender Z End-Stop Spacer

October 14, 2018 · admin 3D Printing object

Put this spacer between the X-Axis and the Z end-stop. It is useful when adding a 3 mm glass on the bed of an Ender-2 or Ender-3 3D printer. It is a lot easier to use this spacer than to move the Z end-stop up. A drop of hot glue is used to maintain it in place.

Power Supply Fan Deflector

October 8, 2018 · admin 3D Printing object

This is a simple power supply fan deflector to redirect the air flow. A few drops of hot glue is used to install it.

PTFE Tube Cutting Guide

September 30, 2018 · admin 3D Printing object

These are 4mm and 6mm PTFE tube cutting guides. Use a very sharp razor blade.

Twin Deep Buckets for Ikea Ivar Shelving System

September 23, 2018 · admin 3D Printing object

These are deep twin buckets to be hanged on the side unit of the Ikea Ivar shelving system. The buckets themselves are 12.5 cm (L) x 4 cm (W) and 8 cm (D). Support is needed. Infill of 20% or above is suggested.

Twin Deep Partitionned Buckets for Ikea Ivar Shelving System

September 16, 2018 · admin 3D Printing object

These are deep partitioned twin buckets to be hanged on the side unit of the Ikea Ivar shelving system. The buckets themselves are 12.5 cm (L) x 4 cm (W) and 8 cm (D). Support is needed. Infill of 20% or above is suggested.

Twin Small Buckets for Ikea Ivar Shelving System

September 10, 2018 · admin 3D Printing object

This is twin small buckets to be hanged on the side unit of the Ikea Ivar shelving system. The buckets themselves are 12.5 cm (L) x 4 cm (W) and 4 cm (D). Support is needed. Infill of 20% or above is suggested.

Ikea Ivar Brackets for 19 Inches Rack Mount Devices

September 3, 2018 · admin 3D Printing object

This is a bracket for 19 inches rack mount devices. You will need to print each file two times. You will need the following hardware to attach the bracket on the Ivar side unit.

Tags