PTFE Tube Cutting Guide
September 30, 2018
· admin
3D Printing
object
These are 4mm and 6mm PTFE tube cutting guides. Use a very sharp razor blade.
Twin Deep Buckets for Ikea Ivar Shelving System
September 23, 2018
· admin
3D Printing
object
These are deep twin buckets to be hanged on the side unit of the Ikea Ivar shelving system. The buckets themselves are 12.5 cm (L) x 4 cm (W) and 8 cm (D). Support is needed. Infill of 20% or above is suggested.
Twin Deep Partitionned Buckets for Ikea Ivar Shelving System
September 16, 2018
· admin
3D Printing
object
These are deep partitioned twin buckets to be hanged on the side unit of the Ikea Ivar shelving system. The buckets themselves are 12.5 cm (L) x 4 cm (W) and 8 cm (D). Support is needed. Infill of 20% or above is suggested.
Twin Small Buckets for Ikea Ivar Shelving System
September 10, 2018
· admin
3D Printing
object
This is twin small buckets to be hanged on the side unit of the Ikea Ivar shelving system. The buckets themselves are 12.5 cm (L) x 4 cm (W) and 4 cm (D). Support is needed. Infill of 20% or above is suggested.
Ikea Ivar Brackets for 19 Inches Rack Mount Devices
September 3, 2018
· admin
3D Printing
object
This is a bracket for 19 inches rack mount devices. You will need to print each file two times. You will need the following hardware to attach the bracket on the Ivar side unit.
TRENDnet TK-207K KVM Holder for Ikea Ivar
August 27, 2018
· admin
3D Printing
object
This is a holder for a TRENDnet TK-207K KVM. The holder is hanged on a unit side of the Ikea Ivar shelving system. The TRENDnet TK-207K is a 2 ports Keyboard/Video/Mouse switch.
Ivar FlashLight Holder 2
August 19, 2018
· admin
3D Printing
object
This is a flashlight holder who is installed on the side unit of the Ivar shelving system. The hole holding the flashlight is 4.5 cm in diameter. It fits flashlight that uses D-cell batteries. You will also need 2 #4-40, 3/8" bolts and the matching nuts. Support material is not needed. An infill of 40% is recommended.
Ikea Ivar Small Bucket
August 12, 2018
· admin
3D Printing
object
This is a small bucket to be hanged on the side unit of the Ikea Ivar shelving system. The bucket is 12.5 cm (L) x 4 cm (W) and 4 cm (D). Support is needed. Infill of 20% or above is suggested.
Ivar FlashLight Holder 1
August 6, 2018
· admin
3D Printing
object
This is a flashlight holder that is installed on the side unit of the Ivar shelving system. The hole that holds the flashlight 4.5 cm in diameter. It fits flashlight that uses D cell batteries.
Ivar Side Unit Drilling Template
July 30, 2018
· admin
3D Printing
object
This is a simple drilling template for the Ivar Shelving System. It is used to drill a hole between two vertical holes of a side unit.