ctheroux.com

ASUS VA32A Monitor Storage Add-On set 3

July 12, 2025 · claude 3D Printing object

These are some add-ons for the ASUS VA32A Monitor Storage. It includes pen and pencil trays. The ASUS VA32A Monitor Storage project is located at http://www.ctheroux.com/asus-va32a-monitor-tray-system/ .

Parametric Macro Pad

July 6, 2025 · claude 3D Printing object

This is a parametric macro pad using a Pi Pico. It uses Cherry MX compatible switches.

Parametric Vesa Monitor Extension

June 28, 2025 · claude 3D Printing object

This is a parametric Vesa Monitor extension. Be careful of the length of it since it's made of plastic. It may either break or you mounting device will break. Use it at your own risk. I'm using it for a 27-inch monitor, held by a vertical 1.25 inch...

Parametric Washer

June 14, 2025 · claude 3D Printing object

This is a simple parametric washer.

Filament Bag Electric Air Pump Case

June 7, 2025 · claude 3D Printing object

This is a case for a filament bag electric air pump widely available.

Utensil Dripper - Dryer

May 31, 2025 · claude 3D Printing object

This is a utensil dripper/dryer, mainly used to air dry utensils. A riser is provided. It let any water that went underneath the dripper dry. A few drops of glue is required is the riser is installed.

Ikea Ivar Pole Cylinders

May 24, 2025 · claude 3D Printing object

These objects are a pair of slanted cylinders that are installed on a post of an Ikea Ivar shelving unit. They can be used to hold flashlights, cans, and so on. A small length of 1.75 mm filament is required to attach the cylinders to the post....

Parametric Watering Can

May 17, 2025 · claude 3D Printing object

Parametric Watering Can --------------------------------------------------------------------------------

Parametric Wire Tube Holder and Wire Cap

May 10, 2025 · claude 3D Printing object

These are a parametric wire tube holder along with a parametric wire cap for already installed wires. A single screw is needed to install one tube holder.

Case for a UT353 Sound Meter

May 3, 2025 · claude 3D Printing object

This is a case for a Uni-T UT353 Sound Meter. It is designed that the foam doesn't touch any surface to prevent deformation. A drop of glue is required to glue the cover lock on the cover itself.

Tags