ctheroux.com

DIY Clock Kit Case (YSZ-4 or ZM-804)

November 23, 2024 · admin 3D Printing object

This is a case for the DIY clock kit YSZ-4 or ZM-804. Two versions are available: one when the display is soldered touching the PCB board and one when the display is soldered above the PCB without cutting the leads of the display. You'll need to print two Push button extensions. A few dabs of glue is required to hold the back to the case.

Electroluminescent Wire (Neon) Power Supply Holder

November 9, 2024 · admin 3D Printing object

This is an electroluminescent wire (neon) power supply holder. Two screws are required to mount it.

Clips For Electroluminescent (Neon) Wires

November 2, 2024 · admin 3D Printing object

These are clips For electroluminescent (neon) wires of 2.25 mm in diameter. Small nails or glue is required to install them. 16 of them are printed at the time. You'll need to cut them out.

Belt Tension Gauge Case

October 26, 2024 · admin 3D Printing object

This is a box to store a Belt Tension Gauge that can be bought on various Chinese website.

TronXY X5SA Entruder and Filament Sensor Mount

October 19, 2024 · admin 3D Printing object

This is a mount for the extruder and the filament sensor for the TronXY X5SA. It replaces the stock mounts. This mount was designed to move both the extruder and the filament sensor in the middle of the back side of the printer. You can then shorten the Bowden tube by about 20 cm (8 inches). You'll need a two 8 mm M5 screws with two T-nuts to mount it to the frame of the printer. You'll also need two M3 20mm screws with nuts to mount the filament sensor to the extruder mount.

Parametric Trays

October 12, 2024 · admin 3D Printing object

These openSCAD scripts generate square, round, rounded corner square trays. Modify the file RoundTray.scad, SquareTray.scad or RoundedCornerSquareTray.scad to get the corresponding tray. ParametricTrays.scad should not be modified

Coffee Filter Dryer

October 5, 2024 · admin 3D Printing object

This is a coffee filter dryer. It also has many other uses such as plant pot base.

MRB063A USB Cable Checker Case

September 28, 2024 · admin 3D Printing object

This is a case for a USB Cable Checker model MRB063A available from many sources such as AliExpress. The top part shall be printed with is face on the bed. The 3mf file contains the top part with lettering to be printed with 2 colors. The USB B connector cap must be glued with a few dabs of superglue. 4 2.5 mm x 5 mm brass inserts along with 4 M2.5 x 8 mm screws are required. They can be replaced with other screws without brass inserts.

Craftsman Flex Claw Holder

September 21, 2024 · admin 3D Printing object

This is a minimalist holder for the Craftsman Flex Claw Holder.

Box for a Plastic Welder

September 14, 2024 · admin 3D Printing object

This is a box for the XCER-110 plastic welder. You will need a dab of glue to attach the lock pin to the cover. A bit of bubble wrap will prevent the welder from moving, but not required. The text in the pictures was added using the slicer.

Tags