3D Printing ABS Juice March 1, 2015
Antre du Tryphon
Search
3D Printing ABS Juice

3D Printing ABS Juice

March 1, 2015 · admin 3D Printing ABS
ABS juice makes the first layer of a print stick very well to the print bed. Put a small quantity of ABS juice on a paper towel and rub it gently on the printing bed. Making ABS juice is simple. In order to do so, you will need:
Read More
Preventing warping when printing 3D ABS objects

Preventing warping when printing 3D ABS objects

February 17, 2013 · admin 3D Printing Prusa Mendel ABS
The biggest issue when printing 3D ABS objects is warping. As an example, this 8 cm x 8 cm bit holder is badly warped. In this example, 5 mm. !](http://www.ctheroux.com/wp-content/uploads/2013/02/dremel-bit-holder-warpage.jpg) Adding disks (1.5 cm x 1 mm) at each corners prevents warping almost completely. These anti-warping disks can be easily added on the plater of Slic3r. The printing end result printing is shown on the picture below. 1 cm x 0.6 cm disks also works fine.
Read More

Tags