TronXY X5SA Entruder and Filament Sensor Mount

October 19, 2024 3D Printing object

Description

This is a mount for the extruder and the filament sensor for the TronXY X5SA. It replaces the stock mounts. This mount was designed to move both the extruder and the filament sensor in the middle of the back side of the printer. You can then shorten the Bowden tube by about 20 cm (8 inches). You'll need a two 8 mm M5 screws with two T-nuts to mount it to the frame of the printer. You'll also need two M3 20mm screws with nuts to mount the filament sensor to the extruder mount.

Support material is not required. An infill of 25% is recommended.

This object was designed using Solid Edge Community Edition.

Files

ExtruderModuleHolder.stl

This object is also published on the following site(s):

TronXY X5SA Entruder and Filament Sensor Mount (420)

You may request the source file(s) for this object by posting a comment below. Your email address will be used solely to deliver the requested source file(s) and for no other purpose.

By requesting the source file(s), you are granted permission to:

Share — Copy and redistribute the material, excluding the source file(s), in any medium or format.
Adapt — Remix, transform, and build upon the material.

By requesting the source file(s), you also agree to:

Give appropriate credit, provide a link to the license, and indicate whether changes were made. You may do so in any reasonable manner, provided that it does not suggest that the licensor endorses you or your use.
Not use the material for commercial purposes.
Distribute any derivative works under the same license as the original if you remix, transform, or build upon the material.
Not apply legal terms or technological measures that legally restrict others from exercising the rights granted by the license.
Not upload the source file(s) or any modified versions of the source file(s) to any website or file-sharing service.
The source file(s) are provided for your personal use only. However, you may freely upload and distribute any STL or OBJ files generated from the source file(s).

If you do not agree to all of these conditions, please do not request the source file(s).

Name

Comment

Do you agree to all these conditions?

This form cannot be submitted until 30 seconds have elapsed. You have time to read the conditions and fill out the form.