FLSun Cube Bed Level Adjustment Tool
Description
This is a simple tool to adjust the level of the bed of a FLSun Cube. Likely, it can be used with other printers such as the CR-10.
Print two tools and use then on both sides of the bed as shown in the picture. It will be a pretty good starting point to level your bed.
Support is not required. The infill can be set to as low as 10%.
This object was designed using Fusion 360
Files
|
|
Bed-Leveling-Tool.stl |
This object is also published on the following site(s):
The source files are available
You may request the source file(s) for this object by posting a comment below. Your email address will be used solely to deliver the requested source files and for no other purpose.
By requesting the source files, you are granted permission to:
- Share — Copy and redistribute the material, excluding the source files, in any medium or format.
- Adapt — Remix, transform, and build upon the material.
By requesting the source files, you also agree to:
- Give appropriate credit, provide a link to the license, and indicate whether changes were made. You may do so in any reasonable manner, provided it does not suggest that the licensor endorses you or your use.
- Not use the material for commercial purposes.
- Distribute any derivative works under the same license as the original if you remix, transform, or build upon the material.
- Not apply legal terms or technological measures that legally restrict others from exercising the rights granted by this license.
- Not upload the source files or modified versions of the source files to any website or file-sharing service. They are provided for your personal use only. However, you may freely upload and distribute any STL or OBJ files generated from them.
If you do not agree to all of these conditions, please do not request the source files.
Copyright 2012–2026, Claude "Tryphon" Théroux