L'Antre du Tryphon
These are din rail breadboard mounts for 400 and 830 points breadboards. The din rail clips can be attached temporarily to the breadboard base using a piece of 1.75 mm filament. The clips can be attached horizontally or vertically to the breadboard base. They can also be glued to the breadboard base for a permanent setup. Clips shall be printed on their side. The 830 points Breadboard base needs two clips.
Support material is not required. An infill of 20% is recommended.
This object was designed using Solid Edge Community Edition.
Printable Files
| | 830 points breadboard base |
| | 400 points breadboard base |
| | Breadboard Clip |
This object is also published on the following site(s):
* Prusa Printers
* Thingiverse
The source files are available:
You may request the source file(s) of this object. Ask for it by posting a comment below. Your email address will NOT be used for any other purposes than delivering you the source files. By doing so:
You are free to:
| * | Share — copy and redistribute the material except the source files in any medium or format |
| * | Adapt — remix, transform, and build upon the material |
You agree to:
| * | give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. |
| * | not use the material for commercial purposes |
| * | distribute your contributions under the same license as the original if you remix, transform, or build upon the material |
| * | not apply legal terms or technological measures that legally restrict others from doing anything the license permits. |
| * | not upload the source files or modified source files on any sites. They are made available for your personal usage only. Nevertheless, you are allowed to upload the resulting STL or OBJ files. |
If you do not agree to any of these conditions, do NOT request the source files.
Copyright 2012-2023 by Claude “Tryphon” Théroux