L'Antre du Tryphon

This is a paper tissue box cover. Its internal size is 11.4 cm x 22.0 cm x 8.3 cm. Support material is not required. An infill of 20% is recommended.

This is a Parametric Label Holder that can be glued on drawers and so on. The size of the labels is given in the openSCAD log. Support material is not

This is a case for a 32 x 8 LED matrix and an ESP8266 MCU. It runs on 5V (USB). I’ve made a connected clock with it.  Its purpose is

This object is two Harley-Davidson logos, 40 mm and 60 mm, I’ve made for an HD motorcycle fanatic. Support material is not required. An infill of 20% is recommended. This

Box for an Electronic Load ——————————————————————————– This is a box for the commonly available Electronic Load on AliExpress. You’ll need a drop to glue the cover latch (the very tiny

This is a twin Wiha bit holder for Ikea Skadis pegboard. It holds 2 Wiha 7 bits case. A few drops of CA glue is required to glue the pegboard

This object holds a square hygrometer in a 4 liters airtight container. This object was designed to monitor the 3D printing filament moisture. I’ve used a small piece of Velcro

This is a hook to hang a large Dewalt organizer. Support material that touches the build plate is required. An infill of 20% is recommended. A 100% infill is recommended

This to-do list holder is designed to be installed on a Vattenkar desk organizer from Ikea. It uses 3 x 5 inches index card. A template is provided to draw

These spacers let you stack can of food easily. You can customize them using openSCAD. Take a copy of CanStackingDisks_Parameters.scad and update the parameters. Open the file with openSCAD and

Skadis mounting bracket for Nissafors utility cart. ——————————————————————————– This is a mounting bracket to attach a Skadis pegboard to a Nissafors utility cart. You’ll need 4 pieces of each object.

This is a keyboard riser for the Kingston Hyper X Alloy FPS Pro, mini USB edition. Support material is not required. An infill of 20% is recommended. This object was

This is a device that holds cards that identify the filament stored in a 4 litres airtight container. This design is slightly curved to fit the end of the container.

This is a device that holds cards that identify the filament externally used by the Bambu Lab printer. The size of the cards are 42.3 mm x 76 mm, which

This is a box for the TSH-06F Integrated Circuit Tester. You will need a dab of glue to attach the lock pin to the cover. A bit of bubble wrap

This is a 20 M900 soldering iron tips case along with the CNC Kitchen threaded insert kit. A project is also available that lets you print a cover with some

This is a 12 tips case for a TS-100 soldering iron. Lift lightly the edge of the lid to open it. A project is also available that lets you print

This is a case for a TS-100 soldering iron along with 6 tips and a threaded insert iron tip kit. The threaded insert iron tip kit can be bought on

This is a case for a combo Type C and Type A USB connector Support material is not required. An infill of 20% is recommended. This object was designed using

This is a holder for 1/3 index cards. I’ve designed it to identity the type of filament. A template is given for standard index cards. Support material is not required.