This is a tray designed to be installed on the stand of an LG 27EA33 monitor. You need to print the STL file provided and the same file mirrored. You
This is pad replacements for the Panavise 303 vise. It has groves to hold tubular objects. I’ve printed it in semi-flexible filament but works fine printed in PLA. Support is
This is a modular SBC or Development Board enclosure. Its base design principle is you stack on top of each other plates that hold various devices such as Raspberry
This is a box for a 3.5 inch hard drive and its cover. It was specifically designed to fit in a small safety box often rented by banks. Support
This is an organizer especially designed for an electronic bench to hold small parts, screws, etc. Support is not needed. This object was designed using Solid Edge Community Edition.
This a magazine file 60 mm wide. It is designed for letter size paper. It is by design a bit smaller than the document it holds. It has holes
These are trays to put under a CR-10 3D printer. The separator of one tray are 15 mm in height. For the other one, 38 mm in height which
This is an open box that can be hanged using 2 screws. The diameter of the head of the screw must be less than 1 cm. Its dimensions are
This is a small trashcan for 3D printing. The way the cover is designed, plastic stuff in the trashcan won’t spring back outside it. The trashcan is 80 mm
It is a simple parametric round container. Open the ParametricBox.scad file with openScad ( http://www.openscad.org/ ) Modify the variables in Parameters.scad to suit your needs and save it. Open
This object will let you suspend your wires and probes on a door. To complete this assembly, you will need a pipe or tube of 5/8 in or 16
These are small drawer dividers. There are 2 models. One for the drawer cabinet sold by Canadian Tire. The other one is for drawer cabinet sold by Home Depot.
This is an anti-vibration foot for 40 mm aluminum extrusion. I had good results using semi-flexible filament. I added some anti-sliding pad. They were specifically designed for an Ender-3 printer.
This is a stand for the Kotto Fume extractor that can be bought from Amazon. It raises the fume extractor by 3 cm. It can be printed without support.
This is a spool holder designed for the Prusa MK3S or any Prusa i3 printers. The dimensions of the top of the main plate shoud be 6.25mm x 40mm.
This is a small wire holder. It is designed for 2.36 mm wires in diameter including its insulation. It can be printed without support if printed on its side.
Soldering electronic components using a large solder spool of 454 grams or so is quite inconvenient even if it is mounted on a solder spool holder. I prefer to
This is a simple pull handle. A #10 flat head screw is recommended to fasten it. I suggest using at least 30% infill. Support is not needed. This object
This is a holder for a TRENDnet TK-409K KVM. The holder is hanged on a unit side of the Ikea Ivar shelving system. The TRENDnet TK-409K is a 4
This is a simple OpenSCAD project that generates bumper feet for various objects. It was specifically designed to replace the lost bumper feet of a Falcon Print Trimmer. Printing