Bambu Lab Top LED Strip

This is an object that holds LED strips to be installed on the top glass of a Bambu Lab printer. Even if the light goes through the top glass, it adds enough light to improve significantly the visibility in the chamber. The goal of this design is to be simple and non-intrusive.

You’ll need four riser foot to raise the AMS unit, two pieces of LED strip of less than 1 cm wide, electrical wire and a source of power.

You may need to mirror one of the LED Canopy Holder Braces, so the wire will exit the brace on the side you want. The LED canopy will fit on the Bambu Lab bed if printed diagonally.

Support material touching the bed plate is required only for the pins that goes into the braces. An infill of 20% is recommended.

This object was designed using Solid Edge Community Edition.


Printable Files

  LED strip holder
  LED Canopy Holder Braces
  AMS Riser foot

This object is also published on the following site(s):
Prusa Printers
Thingiverse


The source files are available:

You may request the source file(s) of this object. Ask for it by posting a comment below. Your email address will NOT be used for any other purposes than delivering you the source files. By doing so:

You are free to:

* Share — copy and redistribute the material except the source files in any medium or format
* Adapt — remix, transform, and build upon the material

You agree to:

* give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
* not use the material for commercial purposes
* distribute your contributions under the same license as the original if you remix, transform, or build upon the material
* not apply legal terms or technological measures that legally restrict others from doing anything the license permits.
* not upload the source files or modified source files on any sites. They are made available for your personal usage only. Nevertheless, you are allowed to upload the resulting STL or OBJ files.

If you do not agree to any of these conditions, do NOT request the source files.


Copyright 2012-2024 by Claude “Tryphon” Théroux

1 thought on “Bambu Lab Top LED Strip

Leave comment

Your email address will not be published. Required fields are marked with *.

Time limit is exhausted. Please reload the CAPTCHA.