L'Antre du Tryphon
These spacers let you stack can of food easily. You can customize them using openSCAD. Take a copy of CanStackingDisks_Parameters.scad and update the parameters. Open the file with openSCAD and Use F5, F6 and F7 to create the related STL file. The diameter of the spacer should be 5 mm smaller than the diameter of the can.
Support material is not required. An infill of 20% is recommended.
This object was designed using openSCAD.
Printable Files
| | Spacer of 6 cm in diameter, 7 mm thick. |
| | Spacer of 8 cm in diameter, 7 mm thick. |
| | Spacer of 9.5 cm in diameter, 7 mm thick. |
| | Can stacking disk parameters |
| | Can stack disk generator |
This object is also published on the following site(s):
* Thingiverse
* Prusa Printers
* MakerWorld
Copyright 2012-2025 by Claude “Tryphon” Théroux