L'Antre du Tryphon
This is a holder for a power brick of 18 cm (7 inches) in length, 4.5 cm (1 3/4 inch) tick and typically 7 cm (2 3/4 inches) in height. Nevertheless, it can be lower or higher.
No support is needed.
This object was designed using Fusion 360
Printable Files
This object is also published on the following site(s):
* Thingiverse
The source files are available:
You may request the source file(s) of this object. Ask for it by posting a comment below. Your email address will NOT be used for any other purposes than delivering you the source files. By doing so:
You are free to:
| * | Share — copy and redistribute the material except the source files in any medium or format |
| * | Adapt — remix, transform, and build upon the material |
You agree to:
| * | give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. |
| * | not use the material for commercial purposes |
| * | distribute your contributions under the same license as the original if you remix, transform, or build upon the material |
| * | not apply legal terms or technological measures that legally restrict others from doing anything the license permits. |
| * | not upload the source files or modified source files on any sites. They are made available for your personal usage only. Nevertheless, you are allowed to upload the resulting STL or OBJ files. |
If you do not agree to any of these conditions, do NOT request the source files.
Copyright 2012-2020 by Claude “Tryphon” Théroux
Hi
Can I please have source files for your power brick design..Looks awesome
thanks
Hi,
you’ll shortly receive a link to download the source file.
Regards
Hello. This is a great design. May I please have the source files? I would like to update it to fit the transformer I have. Thank you.
Hi, you will receive shortly a link to download the source file. Regards, Claude