ALTERA Cyclone II FPGA Development Board Mounting and Drilling Plates
Description
This thing contains a mounting plate and a drilling guide for the “ALTERA Cyclone II FPGA Development Board”.
The base plate is 1.5 mm thick. M2 5 mm or 1/4″ 4-40 screws are needed to fasten the board to the mounting plate. The mounting holes are three mm in diameter.
The holes do not go through the lower layer to make it easier to print. You will have to drill them.
Printable Files
Altera Cyclone II Dev Board Mounting Plate | |
Altera Cyclone II Dev Board Drilling Guide |
Copyright 2012-2015 by Claude Théroux
1 thought on “ALTERA Cyclone II FPGA Development Board Mounting and Drilling Plates”
Comments are closed.