CR-10 X-axis Height Adjustment Tool


This is a X axis height adjustment tool designed for the CR-10, especially if the Z axis upgrade is installed. Nevertheless, it can be certainly used for other 3D printers.

You need to print two tools to use it.

  • Move the extruder in the middle on the X-axis.
  • Put the adjustement tools on the bottom frame on each side of the X-axis as shown on the main photo.
  • Turn the lead screws manually until the X-axis sits on the adjustement tools on both sides.
  • Remove the tools and adjust your bed.

The tool is about 100 mm in height, 21 mm deep and 10 mm wide.


Printable Files

X-axis Height Adjustment Tool


Copyright 2012-2017 by Claude Théroux


Blue Taste Theme created by Jabox