pcDuino V2 Board Drilling And Mounting Plates
Description
This thing contains a mounting plate and a drilling guide for the “pcDuino V2 Board”.
The plates are not symmetrical. The notch shall be on the USB connectors’ side. The base plate is 2 mm thick. M2 5 mm or 1/4″ 4-40 screws are needed to fasten the board to the mounting plate. The mounting holes are three mm in diameter.
The holes do not go through the lower layer to make it easier to print. You will have to drill them.
Printable Files
pcDuino V2 Mounting Plate | |
pcDuino V2 Drilling Guide |
Copyright 2012-2015 by Claude Théroux
1 thought on “pcDuino V2 Board Drilling And Mounting Plates”
Comments are closed.