Raspberry Pi Model B+ Drilling And Mounting Plates

Raspberry Pi B Plus view 2
Raspberry Pi B Plus view 1 Raspberry_Pi_B_Plus_Mounting_Plate_preview_featured Raspberry_Pi_B_Plus_Drilling_Guide_preview_featured

 

Description
This thing contains a mounting plate and a drilling guide for the “Raspberry Pi Model B+”.

The plates are not symmetrical. The notch shall be on the power jack and ethernet cable side. The base plate is 2 mm thick. M2 5 mm or 1/4″ 4-40 screws are needed to fasten the board to the mounting plate. The mounting holes are three mm in diameter.

The holes do not go through the lower layer to make it easier to print. You will have to drill them.

 

Printable Files

Raspberry_Pi_B_Plus_Mounting_Plate_preview_featured Raspberry Pi B Plus Mounting Plate
Raspberry Pi B Plus view 1 Raspberry Pi B Plus Drilling Guide

 

Copyright 2012-2015 by Claude Théroux

 

1 thought on “Raspberry Pi Model B+ Drilling And Mounting Plates”

Comments are closed.