SparkFun RFID USB Reader mounting plate and drilling guide

view2 view3 view4


This thing contains a mounting plate and a drilling guide for the “SparkFun RFID USB Reader” (SEN-09963).

The base plate is one mm thick. M2 5 mm or 1/4″ 4-40 screws are needed to fasten the board to the mounting plate. The mounting holes are three mm in diameter.

The holes do not go through the lower layer to make it easier to print. You will have to drill them.

This thing is a complement to Enclosure for the Sparkfun RFID USB Reader.


Printable Files

view3 Sparkfun USB RFID Board Mounting Plate
view4 Sparkfun USB RFID Board Drilling Guide


Copyright 2012-2015 by Claude Théroux