L'Antre du Tryphon

  This is a compact rack for the Mastercraft Insulated Precision Screwdrivers set (6 pieces) (#057-3604-2) No support is needed if printed on its side. This object was designed using

  This is a caddy that can hold up to 18 Airbush Paint Bottles. The bottle can have a diameter of up to 30 mm. The design allows to print

  This is a simple rack that holds 4 single edge razor blades. Support is not needed. This object was designed using Fusion 360 Printable Files    Single Edge Razor

  This is a compact rack for the Pro’s Kit 7 Pcs Electronics Hex Nut Driver Set (#1PK-9402). If printed on its side, no support is needed. This object was

  This simple white board organizer can hold 10 markers along with the eraser. Support is not required. This object was designed using Fusion 360 Printable Files    White Board

  The Y-Axis must be moved if a motor damper is installed. Otherwise, the carriage will hit the motor. The original Y-axis end stop holder is designed to use M4

  This is a compact rack for the Wera 1578 A/6 Electronics Screwdriver Set. It takes less space the supplied one. If printed on the side, no support is needed.

  This is a stand for the Gocheer airbrush model 180. Support is not required. 15% infill is enough. This object was designed using Fusion 360 Printable Files    Gocheer

  This is a mounting bracket for a small thermometer. You can buy it on AliExpress for about $1.00. I use it to monitor the temperature inside the enclosure of

  Yes, another 3D Printing Tool Caddy! It contains only the essential tools. It can hold: Two glue sticks Twezzer Flush cutter X-Acto knife Flashlight Spatula No support is required.

  The way the FLsun QQ is designed makes it easy to enclose it. Printing ABS is possible with this enclosure. The printer sides are covered with a five mm

  Put this spacer between the X-Axis and the Z end-stop. It is useful when adding a 3 mm glass on the bed of an Ender-2 or Ender-3 3D printer.

  This is a simple power supply fan deflector to redirect the air flow. A few drops of hot glue is used to install it. Support is not required. Simply

  These are 4mm and 6mm PTFE tube cutting guides. Use a very sharp razor blade. This object was designed using Fusion 360 Printable Files    PTFE 4mm Cutting Guide

  These are deep twin buckets to be hanged on the side unit of the Ikea Ivar shelving system. The buckets themselves are 12.5 cm (L) x 4 cm (W)

  These are deep partitioned twin buckets to be hanged on the side unit of the Ikea Ivar shelving system. The buckets themselves are 12.5 cm (L) x 4 cm

  This is twin small buckets to be hanged on the side unit of the Ikea Ivar shelving system. The buckets themselves are 12.5 cm (L) x 4 cm (W)

  This is a bracket for 19 inches rack mount devices. You will need to print each file two times. You will need the following hardware to attach the bracket

  This is a holder for a TRENDnet TK-207K KVM. The holder is hanged on a unit side of the Ikea Ivar shelving system. The TRENDnet TK-207K is a 2

  This is a flashlight holder who is installed on the side unit of the Ivar shelving system. The hole holding the flashlight is 4.5 cm in diameter. It fits