Year: 2020
ESP8266 Motion Sensor Case
This is a case for a motion sensor based on the ESP8266 and the HC-SR501, a PIR (motion) sensor. Support is not required. This object was designed using Fusion
Read More4 inches x 0.7 inches Label Holder
This is a paper tag holder made out of 4 inches (10.1 cm) x 3 inches (7.6 cm) index cards. They fit an edge of about 1/4 (6.25 mm)
Read MoreHanging Buckets for Power Supplies
This kit of objects is two hanging buckets set for a cheap bench power supply. One bucket is 100 mm deep. The other is 50 mm deep. They are
Read MoreIkea Bror Caster Holder
This object lets you install casters to a Bror workbench. It is designed for 1-7/8″ (48.5 mm) x 2-9/16″ (65.5 mm) casters. The holes for the bolts are 2-1/8″
Read MoreIkea Ivar Vesa 100mm Mount
This is a 100 mm VESA mount designed to be mounted on the Ikea Ivar side units. As shown on the picture, I have used it to mount a
Read MoreIvar Side Unit Pin Hook
This is a small pin design to hang stuff on the vertical post of Ikea Ivar side units. The pin is 3mm in diameter, 10 mm long. Support is
Read MoreZip Tie Sleeves for the Ivar System
This is a sleeve for Zip Ties. Its main utility is to protect the vertical supports of the Ikea Ivar system when using Zip Ties to attach stuff. They
Read MoreEN-EL10 Battery Tray
This is two battery tray design for the EN-EL10 batteries. They are used by Nikon for their point and shoot cameras. One of the design holds 6 batteries while
Read MoreIN-12B Nixie Tube Storage Tray
This is a storage tray designed to hold 12 IN-12 Nixie Tubes. Each compartment is 30.5mm x 20.5mm x 20mm in height. It can be printed without support. This
Read MoreStanley Picks and Hooks Pegboard Holder
This is a simple holder for the set of 4 Picks and Hooks made by Stanley. It is designed for the north American pegboard. The holes are 1 inch
Read More